// // JiffyDOS protocol support for IEC - optimized load loop // #if CONFIG_IEC_JIFFYDOS // XXX add RUN/STOP support load_jiffydos: // Timing is critical, do not allow interrupts sei // Store previous sprite status in temporary variable jsr jiffydos_prepare sta TBTCNT // XXX For the first iteration load the whole sector minus 2 bytes // XXX (as they are used to store the start address) // XXX ldy #$FB ldy #$00 // FALLTROUGH load_jiffydos_loop: // Wait until device is ready to send jsr iec_wait_for_clk_release // Prepare 'start sending' message lda CIA2_PRA and #$FF - BIT_CIA2_PRA_DAT_OUT // release tax // Wait for appropriate moment jsr jiffydos_wait_line // XXX try to inline this, maybe one raster is enough? // Ask device to start sending bits stx CIA2_PRA // cycles: 4 // Prepare 'data pull' byte, cycles: 3 + 2 + 2 = 7 lda C3PO ora #BIT_CIA2_PRA_DAT_OUT // pull tax // Delay, JiffyDOS needs some time, 4 cycles nop nop // Get bits, cycles: 4 + 2 + 2 = 8 lda CIA2_PRA // bits 0 and 1 on CLK/DATA lsr lsr // Wait for the drive, cycles: 2 nop // Get bits, cycles: 4 + 2 + 2 = 8 ora CIA2_PRA // bits 2 and 3 on CLK/DATA lsr lsr // Get bits, cycles: 3 + 4 + 2 + 2 = 11 eor C3PO eor CIA2_PRA // bits 4 and 5 on CLK/DATA lsr lsr // Get bits, cycles: 3 + 4 = 7 eor C3PO eor CIA2_PRA // bits 6 and 7 on CLK/DATA // Store retrieved byte, cycles: 6 sta (EAL),y // Retrieve status bits, cycles: 4 bit CIA2_PRA // Pull DATA at the end, cycles: 4 stx CIA2_PRA // If CLK line not active - this was the last byte bvs load_jiffydos_end // Advance pointer to data XXX use INY instead, advance once per sector only jsr lvs_advance_EAL jmp load_jiffydos_loop load_jiffydos_end: // Save last byyte tax // Indicate that no byte waits in output buffer lda #$00 sta C3PO // Restore proper IECPROTO value lda #$01 sta IECPROTO // Re-enable sprites lda TBTCNT sta VIC_SPENA // Store last byte as unoptimized LOAD would stx TBTCNT // End of load loop jmp load_iec_loop_end #endif // CONFIG_IEC_JIFFYDOS