// #LAYOUT# STD * #TAKE // #LAYOUT# * KERNAL_0 #TAKE // #LAYOUT# * * #IGNORE // // Advertise burst IEC protocol support to the receiver // // // Based on idea by Pasi 'Albert' Ojala and description from // https://sites.google.com/site/h2obsession/CBM/C128/fast-serial-for-uiec // #if CONFIG_IEC_BURST_CIA2 burst_advertise: #if CONFIG_IEC_JIFFYDOS // Skip if other protocol (only JiffyDOS is possible at this moment) already detected lda IECPROTO bmi !+ bne burst_advertise_done !: #endif // Make sure this is not done under ATN jst iec_release_atn // Set the clock rate to the fastest possible ldy #$01 sty CIA2_TIMALO dey sty CIA2_TIMAHI // Prepare registers for transfer lda #$C1 sta CIA2_CRA // start timer A, serial out, TOD 50Hz bit CIA2_ICR // clear interrupt register // Send test byte lda #$FF // $FF keeps DATA released, see https://www.c64-wiki.com/wiki/Fast_serial_bus_protocol sta CIA2_SDR // Wait until byte sent lda #$08 // interrupt mask !: bit CIA2_ICR beq !- // FALLTROUGH burst_advertise_done: rts #endif