// // JiffyDOS protocol support for IEC - optimized load loop // #if CONFIG_IEC_JIFFYDOS && !CONFIG_MEMORY_MODEL_60K // Note: original JiffyDOS LOAD loop checks for RUN/STOP key every time a sector is read. // For simplicity and some space savings, our routine does not check the RUN/STOP key at all; // the protocol is fast enough (especiallyy with modern flash mediums) that probably nobody // will want to terminate the loading. load_jiffydos: // Timing is critical, do not allow interrupts sei // Store previous sprite status in temporary variable jsr jiffydos_prepare sta TBTCNT // A trick to shorten EAL update time ldy #$FF // FALLTROUGH load_jiffydos_loop: // Wait until device is ready to send jsr iec_wait_for_clk_release // Prepare 'start sending' message lda CIA2_PRA and #$FF - BIT_CIA2_PRA_DAT_OUT // release tax // Wait for appropriate moment jsr jiffydos_wait_line // XXX try to inline this, maybe one raster is enough? // Ask device to start sending bits stx CIA2_PRA // cycles: 4 // Prepare 'data pull' byte, cycles: 3 + 2 + 2 = 7 lda C3PO ora #BIT_CIA2_PRA_DAT_OUT // pull tax // Delay, JiffyDOS needs some time, 4 cycles nop nop // Get bits, cycles: 4 + 2 + 2 = 8 lda CIA2_PRA // bits 0 and 1 on CLK/DATA lsr lsr // Wait for the drive - we have time to increment offset, cycles: 2 iny // Get bits, cycles: 4 + 2 + 2 = 8 ora CIA2_PRA // bits 2 and 3 on CLK/DATA lsr lsr // Get bits, cycles: 3 + 4 + 2 + 2 = 11 eor C3PO eor CIA2_PRA // bits 4 and 5 on CLK/DATA lsr lsr // Get bits, cycles: 3 + 4 = 7 eor C3PO eor CIA2_PRA // bits 6 and 7 on CLK/DATA // Store retrieved byte, cycles: 6 sta (EAL),y // not compatible with CONFIG_MEMORY_MODEL_60K // Retrieve status bits, cycles: 4 bit CIA2_PRA // Pull DATA at the end, cycles: 4 stx CIA2_PRA // If CLK line not active - this was the last byte bvs load_jiffydos_end // Handle EAL cpy #$FF bne load_jiffydos_loop inc EAL+1 jmp load_jiffydos_loop load_jiffydos_end: // Save last byte tax // Update EAL tya sec adc EAL+0 sta EAL+0 bcc !+ inc EAL+1 !: // Indicate that no byte waits in output buffer lda #$00 sta C3PO // Restore proper IECPROTO value lda #$01 sta IECPROTO // Re-enable sprites lda TBTCNT sta VIC_SPENA // Store last byte as unoptimized LOAD routine would stx TBTCNT // End of load loop jmp load_iec_loop_end #endif // CONFIG_IEC_JIFFYDOS and not CONFIG_MEMORY_MODEL_60K