65 lines
1.9 KiB
ArmAsm
65 lines
1.9 KiB
ArmAsm
|
|
;; Implemented based on https://www.pagetable.com/?p=1135, https://github.com/mist64/cbmbus_doc
|
|
|
|
iec_tx_command:
|
|
|
|
;; Store command to send on the stack
|
|
pha
|
|
|
|
;; Notify all devices that we are going to send a byte
|
|
;; and it is going to be a command (pulled ATN)
|
|
jsr iec_pull_atn_clk_release_data
|
|
|
|
;; Give devices time to respond (response is mandatory!)
|
|
jsr wait1ms
|
|
|
|
;; Did at least one device respond by pulling DATA?
|
|
lda CI2PRA
|
|
and #BIT_CI2PRA_DAT_IN ; XXX try to optimize this, move to separate routine
|
|
beq +
|
|
|
|
;; No devices present on the bus, so we can immediately return with device not found
|
|
pla
|
|
|
|
jsr iec_set_idle
|
|
jmp kernalerror_DEVICE_NOT_FOUND
|
|
*
|
|
;; At least one device responded, but they are still allowed to stall
|
|
;; (can be busy processing something), we have to wait till they are all
|
|
;; ready (or bored with DOS attack...)
|
|
;; Release back CLK, keep DATA released - to ask devices for status.
|
|
|
|
jsr iec_release_clk_data
|
|
|
|
;; Common part of iec_txbyte and iec_tx_common - waits for devices
|
|
;; and transmits a byte
|
|
|
|
clc ; Carry flag set is used for EOI mark
|
|
pla
|
|
jsr iec_tx_common
|
|
|
|
;; According to https://www.pagetable.com/?p=1135 there is some complicated and dangerous
|
|
;; flow here, but http://www.zimmers.net/anonftp/pub/cbm/programming/serial-bus.pdf (page 6)
|
|
;; advices to just wait 1ms and check the DATA status
|
|
jsr wait1ms
|
|
lda CI2PRA
|
|
and #BIT_CI2PRA_DAT_IN ; XXX try to optimize this, move to separate routine
|
|
beq +
|
|
|
|
;; XXX possible optimization of the flow above: for many commands it is enough
|
|
;; to wait for the DATA being pulled, as confirmation is expected from
|
|
;; a single device only - but not sure if it's worth the trouble
|
|
|
|
jsr iec_set_idle
|
|
jmp kernalerror_DEVICE_NOT_FOUND
|
|
*
|
|
;; All done
|
|
|
|
;; XXX All the documentation says we should release ATN at this point, but when I do so
|
|
;; the turnaround mechanism does not work. Why???
|
|
;; jsr iec_wait20us
|
|
;; jsr iec_set_idle
|
|
|
|
clc
|
|
rts
|