Files
open-roms/c64/kernal/iec/f000.iec_jiffydos.s
T

143 lines
2.6 KiB
ArmAsm

//
// JiffyDOS protocol support for IEC
//
// XXX finish this
#if CONFIG_IEC_JIFFYDOS
// JiffyDOS timing regime is very strict - before transmitting anything
// we need to disable sprites and (if screen is not disabled) wait for
// appropriate moment, so that no badline interruption can happen
iec_tx_byte_jiffydos:
jsr jiffydos_hide_sprites
pha // store previous sprite status on stack
// XXX prepare bit pairs too send
// XXX lda TBTCNT
// XXX bits to stack: 0, 2
// XXX bits to stack: 1, 3
// XXX bits to stack: 7, 6
// XXX bits to stack: 5, 4
jsr jiffydos_wait_line
__jd_check1:
// XXX send byte
// Re-enable sprites
pla
lda VIC_SPENA
// XXX reenable screen - temporary, just for testing
lda VIC_SCROLY
ora #$10
sta VIC_SCROLY
rts
iec_rx_byte_jiffydos:
jsr jiffydos_hide_sprites
pha // store previous sprite status on stack
// Wait until device is ready to send
jsr iec_wait_for_clk_release
// Prepare 'start sending' message
lda CIA2_PRA
and #$FF - BIT_CIA2_PRA_DAT_OUT // release
pha
// Wait for appropriate moment
jsr jiffydos_wait_line
// Ask device to start sending bits
pla
sta CIA2_PRA
// XXX retrieve byte
// Re-enable sprites
pla
lda VIC_SPENA
// XXX reenable screen - temporary, just for testing
tay
lda VIC_SCROLY
ora #$10
sta VIC_SCROLY
tya
rts
jiffydos_wait_line:
lda VIC_SCROLY
and #$10
beq jiffydos_wait_line_done // screen is disabled, no need to watch for badlines
// To give the transfer routine as much time as possible,
// wait till a badline
// XXX this is probably overkill, most likely it is enough to avoid 2 (3?) lines
// before badline - to be adjusted in the future
!:
sec
lda VIC_SCROLY
sbc VIC_RASTER
and #$07 // we want 8 lowest bits
bne !-
jiffydos_wait_line_done:
rts
__jd_check2:
jiffydos_hide_sprites:
lda VIC_SPENA
ldx #$00
stx VIC_SPENA
rts
.function SAME_PAGE_CHECK(label_1, label_2)
{
#if PASS_SIZETEST
.return (label_1 - label_1 % 256) == (label_2 - label_2 % 256)
#else
.return true
#endif
}
.if (!SAME_PAGE_CHECK(__jd_check1, __jd_check2))
{
// To meet the strict JiffyDOS timing, we need to make sure
// it does not span across multiple pages, as this would add
// 1 cycle to some jump instructions - maybe this wont cause
// problems, but better safe than sorry.
.error "JiffyDOS code can't span across multiple pages"
}
#endif // CONFIG_IEC_JIFFYDOS